Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75792
1.INSTALL DOOR WINDOW FRAME MOULDING CLIP
Attach the 2 claws to install the door window frame moulding clip.
75076
2.INSTALL REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH
When installing the rear door outside moulding, heat the rear door panel and rear door outside moulding using a heatlight.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| Rear Door Outside Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the rear door panel and rear door outside moulding excessively.
Clean the rear door panel surface.
Using a heat light, heat the rear door panelsurface.
Remove the double-sided tape from the rear door panel surface.
Wipe off any tape adhesive residue withcleaner.
Install a new rear door outside moulding sub-assembly LH.
Using a heat light, heat a new rear door outside moulding sub-assembly LH and the rear door panel surface.
Remove the peeling paper from the face of the rear door outside moulding sub-assembly LH.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
| *1 | Protective Tape |
| *2 | Double-sided Tape |
Attach the clip and double-sided tape to install the rear door outside moulding sub-assembly LH.
Press the rear door outside moulding sub-assembly LH firmly to install it.
67872
3.INSTALL REAR DOOR WEATHERSTRIP LH
Install the rear door weatherstrip LH.
75740
4.INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH
68104
5.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
68124B
6.INSTALL REAR DOOR QUARTER WINDOW GLASS LH
67408E
7.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
8.INSTALL REAR DOOR GLASS RUN LH
67842E
9.INSTALL REAR DOOR SERVICE HOLE COVER LH
67604
10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
69284D
11.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
74646A
12.INSTALL DOOR ASSIST GRIP COVER LH
13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
15.CHECK POWER WINDOW CONTROL SYSTEM
w/o Jam Prptection Function: